XTRIG 70100025 : X-TRIG Holeshot Kit Ø50mm WP Fork KTM/Husqvarna

Your n°1 partner for holeshots

• Easy to install
• No need to remove fork
• The articulation of the ring is placed on the side (not at the clip part, or in front of this section)
• Thanks to this location, the articulation is subjected to low pressure
• Product life extended

The ring is equipped with a 3mm screw (torque of 2.3 Nm). The screw diameter has been studied for tightening torque cannot be too important, and compressing the arm fork.