XTRIG 70100007 : X-TRIG Ø58mm Holeshot Kit Öhlins Forks

Be the holeshot racer with X-Trig holeshot kit

• Easy to install


• No need to remove one side of the fork


• The articulation of the ring is placed on the side (not at the clip part, or in front of this section). Thanks to this location, the articulation is subjected to low pressure


• The life of the product is thus extended


• The ring is equipped with a 3mm screw (torque of 2.3 Nm)


• The screw diameter has been studied for tightening torque cannot be too important, and compressing the arm fork

Fits on:

• WP 48mm Aftermarket Gabel (cone valve)


• XACT PRO 7548


• XACT PRO 7448